UTM and Tool Maintenance

Inspect the UTM o-rings

• It is possible that intense temperature and adverse weather cycles could degrade the rubber o-rings on the bottom of the UTM.

Remove magnet debris

• It is possible for dust, soil, and other debris to magnetically attract to the UTM and Tool magnets and build up over time.

• This debris can prevent the UTM from correctly mounting tools.

Remove internal needle debris

• It is possible for dust, soil, and other debris to become stuck inside of seed injector’s luer loock needles.

• This can cause a loss of seed suction power and prevent the seed injector from working reliably.

Dissolve mineral buildup in the watering nozzle

• It is possible - depending on your water source - for the watering nozzle to slowly become clogged with mineral buildup and other deposits.

• This can prevent AgriBot from watering the correct amount for each plant and can also cause uneven spray.

Remove weeder and soil sensor debris

• It is possible for dirt and other debris to become stuck between the weeder implements or build up on the contacts of the soil sensor which could cause inaccurate readings.